Frequently Asked Questions

Most tubs are reglazed in a single visit, typically 2–4 hours of hands-on work. We’ll walk you through the exact timeline before we start so there are no surprises.

Plan to keep the tub dry for 24–72 hours while the finish fully cures. We’ll give you the exact window for your job and a few tips to protect the surface during that time.

You don’t need to stay for the entire job, but we do ask that someone is available at the start to walk through the space with our technician and at the end to review the finished work.

In short: we clean and de-gloss the surface, repair any chips or cracks, mask off the surrounding area, apply a bonding primer, then spray on multiple coats of Topkote coating. Read our full step-by-step breakdown here.

With proper care, a professionally reglazed tub typically lasts 10–15 years. Longevity comes down to the quality of prep work and coating — corners cut here are the #1 reason DIY and bargain jobs fail early.

Not when it’s done right. Peeling and yellowing are almost always signs of poor surface prep or a low-grade coating. We use Topkote products exclusively, chosen specifically for their adhesion and long-term color stability — backed by our 5-year warranty.

Yes. We offer a range of standard colors and can custom-match in most cases. Let us know what you’re working with and we’ll confirm before the job starts.

No — we finish every tub with a slip-resistant texture as standard, so you’re not trading looks for safety.

Yes, we reglaze all of these surfaces. Each material requires a slightly different prep process, which our technicians assess on-site.

Absolutely — minor to moderate damage is repaired as part of the standard process. For significant structural damage, we’ll let you know honestly if reglazing is still the right fit.

Yes. Many customers do their tub, tile, and sink together for a full bathroom refresh in one visit.

Reglazing typically costs a fraction of full tub replacement, and there’s no demolition, plumbing work, or multi-day install. Our standard reglazing service starts at $450, well below the cost of a new tub and installation.

Yes — it’s one of the highest-return, lowest-cost updates you can make before listing. A worn tub is a red flag for buyers; a like-new one isn’t.

Our standard reglazing service includes surface preparation, minor chip and crack repairs, masking, priming, and application of the new finish. Re-caulking around the tub is also included as part of the service. Tile reglazing, drain work, and additional repairs can be added depending on the condition of the bathroom and the scope of the project.

Yes. We follow strict ventilation and safety procedures throughout the reglazing process to keep the work area properly contained and ventilated. We recommend keeping children and pets away from the work area during application and while the coating cures. Our technician will let you know when the bathroom is ready for normal use again.

There is an odor during and shortly after application, similar to fresh paint. We ventilate the space during the job, and most customers find the smell fades within a day.

We use Topkote products exclusively across every job, chosen for their quality, consistency, and performance.

Stick to non-abrasive cleaners and a soft cloth or sponge. Avoid scouring powders, bleach-based cleaners, and abrasive pads, which can dull or damage the finish over time. We’ll send you a full care guide after your job.

Skip anything abrasive (Comet, Ajax, steel wool) or highly acidic. A mild dish soap and soft sponge is all you need for regular upkeep.

Every job comes with a standard 5-year warranty against peeling, cracking, and discoloration under normal use.

Contact us if you notice peeling, cracking, discoloration, or another issue with the finish. We’ll review the problem and determine what caused it. If the failure is covered under our 5-year warranty, we’ll arrange to repair the affected area at no additional cost.